Single Jet Plus + Water Meter

Installation guidelines:

Sizing and Selection:

• Maximum flow is only for use in emergencies, for about 1-2 minutes as it causes the
  bearings to overheat.
• Minimum flow only refers to the minimum flow required to operate and record on the meter.
  At these very low flows, the meter will not be accurate.
• All water meters should be sized between transitional flow (the point at which the meter is
  most accurate) and nominal flow (everyday flow rate).
• The meters are designed only for use with clean water. Sufficient filtration prior to the meter
  should be considered if the quality of water is compromised.

Installation:

• Under no circumstances whatsoever must the meters remain in situ whilst system flushing
  takes place.
• Note that there is a direction of flow arrow on the meter and the meter should be installed
  accordingly.
• It is recommended as good practice to fit a removable filter element before a water meter to
  protect the mechanism.
• The Single Jet Plus meter can be installed in both the horizontal and vertical position.